throttle lever handle
|
|
throttle lever handle |
|
|
 |
Navigation & Acknowledgements |
throttle lever handle: 2015-01-29
Lumix DMC-FT1
I made this handle for the throttle lever from a piece of 1" round aluminium bar. Each side is identical, and clamped onto the lever by a M5 button-head screw. Boring out the centre on my Cowells 90 lathe produced a lot of swarf!
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2018-12-03, 17:00. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||