 |
Re-bonding port wing TE
|
 |
Re-bonding port wing TE
re-bonding port wing TE: 2008-04-19
Nikon Coolpix 8400
The clamping setup for re-bonding the wing TE in the aileron section, where a combination of insufficent Redux-flox mixture, and poor clamping left some voids between the upper skin and the aileron closeout section of the wing. This time, (after thorough cleaning out, abrading and degreasing) I used neat Redux to be sure it would flow into the narrow gap. There is obviously no shortage of Redux this time; you can see it overflowing from the bond area beside the nearest orange clamp. I used layers of polyethylene sheet everywhere to ensure that the Redux didn't flow anywhere it wasn't wanted; that was a bit tedious to apply but was very worthwhile as it made cleanup of the surplus easy afterwards.
|
This page last updated 2012-12-12.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages