 |
sanding through filler on starboard aileron
|
 |
sanding through filler on starboard aileron
sanding pant & filler off starboard aileron: 2017-09-18 Panasonic DMC-FT1
The underside of the starboard aileron after more vigourous sanding; the DA sander was not making enough progress so I switched to the belt sander with a 120 grit belt, using it at the lowest speed and very gentle pressure, while moving around to make sure I am not going too deep.
|
This page last updated 2017-10-21.
I try to make this page as accessible as possible,
by adhering to HTML 4 standards.
|
|
|
|
I welcome comments on this website. However, because of the
amount of spam it attracts, I no longer post a direct e-mail
address on any page. Instead, please
click here to contact me.
You will have to confirm that you are human before the message
will be sent on to me.
|
go to previous picture page 
go to list of photo pages