TP10 drill setup
|
|
TP10 drill setup |
|
|
 |
Navigation & Acknowledgements |
Setup for drilling TP10: 2011-11-25
Lumix DMC-FT1
Setting up the mini-mill for drilling through TP10. Centring the drill bit by gently lowering the point of the drill bit onto a steel rule laid on the cylindrical surface, and moving the workpiece left & right until the rule is held horizontal.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2013-01-02. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||