shortening FL15 cross-tube
|
|
shortening FL15 cross-tube |
|
|
 |
Navigation & Acknowledgements |
2 pictures on this page - scroll down to see the rest
shortening flap cross-tube: 2015-02-06
Lumix DMC-FT1
Shortening the FL15 flap cross-tube. About 1.5mm needed to come off each end. This is part-way through the hacksaw cut at the second end.
flap cross-tube shortened: 2015-02-06
Lumix DMC-FT1
The very thin offcut resulting from shortening the FL15 flap cross-tube by about 1.5mm at each end.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2015-03-03. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||