Routing out brown foam
|
|
Routing out brown foam |
|
|
 |
Navigation & Acknowledgements |
cutting out brown foam: 2009-04-25
Nikon Coolpix 8400
Routing out the brown foam between the pre-preg layers in the seat. The foam must be removed to allow the edge of the hole to be strengthened with flox. This is a Dremel 199 tool, which looks like a tiny circular saw about 1mm thick. It removes the central foam layer very effectively without much danger of damage to the outer epoxy/glass layers.
 go to previous picture page |
back to journal page |
go to next picture page |
 go to list of photo pages
|
||
| Return to Rowland's home page |
| This page last updated 2012-12-12. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on any page. Instead, please click here to contact me. You will have to confirm that you are human before the message will be sent on to me. | ||